Sludge Drying with Solar and Renewable Energy
The HUBER Solar-Regenerative Sludge Dryer SRT is able to meet the most different specific customer requirements, whether as a pure solar dryer or all-year-round dryer operated with additional heat. Also the automation degree of sewage sludge feeding and removal is variable.
The combined sludge turning and transporting system is at the heart of the drying plant. The sludge is transported through the hall virtually continuously or as an option in batches. With its double shovel the turning/transporting unit can not only aerate, break up and move the sludge through continuous shovelling but also achieve a controlled distribution of sludge in its shovels. Due to the latter function of the shovel sludge can be back-mixed or sludge feeding and removal take place at the same hall side.
The dryer consists of a transparent thermo shell in which the turning/transporting unit distributes the sludge all over the area. The air and sludge bed are heated by solar radiation. Low temperature heat can be added via an underfloor heating. The underfloor heating can be operated with exhaust heat from a block heat and power plant or by means of a heat pump which uses the heat contained within wastewater (WWTP effluent).
(See also HUBER Solution Sludge Drying with Wastewater Heat)
If an additional floor heating is used, space requirements are smaller compared to pure solar drying and plant operation is possible all year round even in areas offering only moderate or rare solar radiation.
The liquid sludge can be pre-dewatered in our HUBER Screw Press Q-PRESS®. Sludge feeding can for example be accomplished by means of a screw that distributes the dewatered sludge cake at one gable side over the full width of the thermo shell. The special HUBER sludge turner SOLSTICE® travels on tracks. While continuously being restacked by the turner, the sludge on the floor is slowly transported to the other end of the hall. On its way through the hall, the sludge is being dried by solar radiation. As an option, heat can be added via a floor heating. The dried material has a solids content of at least 65% and can be discharged into a container by means of a ROTAMAT® Screw Conveyor.
Where no, or not sufficient heat is available, we withdraw heat from treated wastewater (See also our HUBER Solution Sludge Drying with Wastewater Heat).
Advantages of Sludge Drying with Solar and Regenrative Energy
- Dry, granular and safe to handle product with over 65 % solids content
- Moderate drying temperature - no odour nuisance
- Little dust generation - safe operation
- Use of solar energy and low-temperature (waste) heat
- Independent of season and climate
- Small footprint
- Low operation and maintenance costs